LOAD RESISTOR
INSTALLATION
Wiring
diagram: Black wire (Negative) Red
wire (POSITIVE TURN SIGNAL WIRE)
Connect
the yellow wires to the positive turn signal wires using provided
red connectors or alternately use your existing factory
connectors. Ground wire is not needed unless you are using resistors to
slow down the blink rate. (The ground wire is the same color wire
used on both turn signals). To slow down the blinking rate
use provided resistors. Connect one end of resistor to the
yellow wire and the other end of resistor to the negative turn
signal wire.
Note: You can use an electrical variable load
flasher. CLICK here for instructions on how to
install. Resistors
are not needed if you choose to use the variable load
flashers.
