STEP 1 REMOVE THE FRONT TURN SIGNAL USING A 8MM

STEP 2 YOU MIGHT HAVE TO REMOVE THE INNER FAIRING COVER PLATES TO MAKE THE JOB EASIER

STEP 3 CUT THE WIRES OFF THE FACTORY SIGNALS

TO HOOK UP THE LOAD RESISTOR YOU HOOK THE RED TO THE LED RED AND THE RESISTOR BLACK WIRE TO THE LED BLACK THEN HOOH THE LEADS TO THE BIKES TURN SIGNAL LEADS

STEP 4 PUT THE THINNER PLATE ON THE BACK SIDE OF THE FAIRING AND THE THICKER PLATE ON THE FRONT SIDE

STEP 5 MOUNT THE LED TO THE PLATES AND TIGHTEN THE SCREWS TILL THE PLATES ARE SNUG

THIS IS WHAT YOUR LED FRONT TURN SIGNAL SHOULD LOOK LIKE