STEP 1 REMOVE THE FACTORY SIGNAL BY PULLING ON IT TILL IT PULLS OUT

STEP 2 PUT THE LED THROUGH BOTH PLATES

STEP 3 PUT ONE OF THE PLATES ON THE BACK SIDE OF THE FAIRING TIGHTEN THE SCREWS TILL THE PLATES ARE SNUG

TAKE THE RED OF THE RESISTOR ATTACH IT TO THE RED OF THE LED AND THE BLACK OF THE RESISTOR ATTACH IT TO THE BLACK WIRE OF THE LED THEN ATTACH THEM TO THE TURN SIGNAL WIRES

THE GREEN IS POSITIVE AND THE BLACK IS NEGATIVE

 THIS IS WHAT YOUR LED TURN SIGNAL SHOUND LOOK LIKE